Solutions recommended according to material, condition, performance requirements, site constraints and budget.
Solid timber, engineered timber, hardwood, softwood, strips, battens and selected decorative products supplied according to project requirements. Selection considers appearance, durability, moisture, traffic, location, maintenance and budget.
Installation is planned around the selected system and site condition, including substrate assessment, setting-out, alignment, movement allowance, adhesive or mechanical fixing, finishing details and protection.
Supporting structure, drainage, ventilation, board spacing, movement allowance, fixing method and future maintenance access are considered before installation.
Where consistent appearance and reduced routine surface maintenance are required, we assess support, drainage, ventilation, span, expansion allowance and fixing details.
Timber ceilings, feature battens and indoor or outdoor cladding installed with attention to substructure, alignment, access, ventilation, movement, fixing and service coordination.
Screens, slatted partitions, feature panels, staircase elements and architectural details measured, set out and installed according to approved drawings, material and site conditions.
Existing floors are assessed for damage, movement, staining, previous coatings and remaining sanding allowance. Where suitable, Timberplus uses professional Bona sanding, dust-containment and waterborne finishing systems with the agreed sheen and coating specification.
Dust-contained sanding · Timber repair · Gap filling · Board replacement · Bona waterborne finishing
Marble condition is assessed before cleaning, stain treatment, grinding, honing or polishing is recommended. The process is selected according to the stone, level of wear, staining and required finish. Faber professional stone-care products may be used where appropriate to the treatment plan.
Typical work: grinding & levelling · honing · polishing · scratch reduction · joint or chip repair · sealing
Homogeneous tiles can lose clarity and develop traffic wear, ingrained dirt and an uneven appearance over time. After assessing the tile condition, Timberplus recommends suitable deep cleaning, resurfacing or polishing to improve appearance and ease of maintenance where practical.
Typical work:deep cleaning · mechanical scrubbing · grout cleaning · surface refinement · polishing where suitable · protective treatment
We identify visible defects, likely treatment limitations and suitable next steps so clients can make a practical decision. Any advice or estimate based only on photographs remains provisional until site conditions are confirmed.
